Air-fuel mixing and combustion behavior of gasoline-ethanol blends in a GDI wall-guided turbocharged multi-cylinder optical engine
Academic Article
Publication Date:
2016
abstract:
The investigation of phenomena involved in gasoline direct injection 4-stroke, 4-cylinder, opticallyaccessible
engine were carried out at part load and speed condition with different ethanol-gasoline
blends. The influence of injection pressure on ethanol addition, at percentages of 10%, 50% and 85%,
was investigated by conventional and optical diagnostics. Combustion characteristics, such as mass
fraction burned, heat release rate and combustion duration were calculated based on in-cylinder pressure
curve data, Emissions of UHC, NOX, CO, CO2, and PM were measured. The injection and combustion
phase by high spatial and temporal optical measurements were characterized. The spray penetration,
and the flame structure and propagation speed were obtained by optical data.
The addition of ethanol in gasoline allowed an improvement of engine performance in terms of IMEP
and COVIMEP and emissions. In particular, for E50 the better performance was obtained thanks to an
earlier vaporization during the injection and a spray almost compact with a higher penetration especially
at 100 bar, that avoided the formation of liquid fuel deposits on the piston and subsequently pollutants in
the exhaust. Meanwhile, for E85 the spray was characterized by a slower vaporization that created a less
homogeneous charge and reduction of the flame front propagation in the late propagation phase. This
allows a faster and more efficient combustion with respect to fuels characterized by high gasoline
fraction.
Finally, E85 and E50 showed higher values of the integral flame luminosity in the first phase of
combustion due to the higher flame speed with respect to gasoline one. Moreover, the chemiluminescence
imaging confirmed a lower number of diffusive flames with respect gasoline and E10 in
the late combustion phase, when the flame burns the fuel film on the piston crown. These results
validated the lower emission of UHC and smoke of E50 and E85 with respect to gasoline and E10.
Iris type:
01.01 Articolo in rivista
Keywords:
Direct injection SI engine Ethanol blends In-cylinder optical diagnostics; Spray analysis; Charge formation; Combustion process characterization; Emissions
List of contributors:
Sementa, Paolo; Catapano, Francesco; Vaglieco, BIANCA MARIA
Published in: