The Portofino Conglomerate (Eastern Liguria, Northern Italy): Provenance, Age and Geodynamic Implications

The Portofino Conglomerate (PC) cropping out in the Eastern Liguria is an approximately 500 m thick, very gently folded succession mainly composed of poorly bedded and mostly matrix-supported conglomerates. It stratigraphically rests on the Helminthoid Flysch (UA3) thrusted onto the Antola Unit. We vertically distinguished three mostly ruditic litho/petrofacies: (i) Paraggi (fP) with carbonate clasts from an Helminthoid Flysch succession; (ii) Monte Pallone (fMP) with prevailing carbonate and meta-carbonate clasts and minor quartz-rich (meta)siliciclastic and high-pressure- low-pressure (HP-LP) metabasite clasts; and (iii) Monte Bocche (fMB) with dominant quartz-rich (meta)siliciclastic, meta-carbonate clasts, and minor granitoid elements and medium-temperature- high-temperature (MT-HT) regional metamorphic rocks. The middle-upper Eocen age of Paraggi litho/petrofacies is constrained by well-preserved microforaminifers (e.g., Globigerinatheka) recovered in the matrix. During its sedimentation, the directions of the paleocurrents would indicate that the PC underwent a counterclockwise rotation coeval with the first Cenozoic rotational phase of the Sardinia-Corsica system (50-30 Ma) and then stopped before the sedimentation of the Monte Pallone and Monte Bocche litho/petrofacies. The vertical compositional variation in the sedimentary inputs suggested that the PC is the result of a progressive deepening of the erosional level of a tectonic pile that can be located in the Ligurian Alps Chain. We considered the PC as the likely apical part of a submarine fan deposited in a piggy-back/thrust-top basin within the Alpine nappe stack. This sedimentary body was later tectonically transported eastward with its UA3 Helminthoid Flysch substrate (similarly to Epiligurian Units of the Northern Apennines) onto the Apenninic orogenic system (i.e., the Antola Unit).