Modeling, Design, and Fabrication of High Inductance Bond Wire Micro-Transformers with Toroidal Ferrite Core

This paper presents the design of miniaturized bond wire transformers assembled with standard IC bonding wires and NiZn and MnZn ferrite toroidal cores. Several prototypes are fabricated on a PCB substrate with various layouts in a 4.95 mm × 4.95 mm area. The devices are modeled by analytical means and characterized with impedance measurements over a wide frequency range. Experimental results on 1 : 38 device show that the secondary self-inductance increases from 0.3 ?H with air-core to 315 ?H with ferrite core; the coupling coefficient improves from 0.1 with air-core to 0.9 with ferrite core; the effective turns ratio enhances from 0.5 with air-core to 34 with ferrite core. This approach is cost-effective and enables a flexible design of efficient micro-magnetics on-top of ICs with DC inductance to resistance ratio of 70 ?H/? and an inductance per unit area of 12.8 ?H/mm2 up to 0.3 MHz. The design targets the development of bootstrap circuits for ultra-low voltage energy harvesting. In this context, a low voltage step-up oscillator suitable for TEG sources is realized with a commercial IC and the proposed micro-transformers. Experimental measurements on a discrete prototype report that the circuit bootstraps from voltages down to 260 mV and outputs a DC voltage of 2 V